Home / Forum / Builds and Things Built / MPCNC 2.8w $100 laser add-on complete / Reply To: MPCNC 2.8w $100 laser add-on complete

Profile photo of Maker BakerMaker Baker
Post count: 39
#7905 |

I am done all the hardware setup, almost.. but I have a really stupid question. ive always flashed my changed and flashed firmware on my printers threw Arduino.ino but I couldn’t get the file “pins RAMPS_13.h in the tabs. so I opened it with a text editor and changed the pin out as instructed. but now how do I flash it over? will the change be done if I do it threw Arduino.ino like i always do even if the pins_RAMPS_13.h is not listed in the tabs?