Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#7963
Profile photo of Leo69
Leo69
Participant

I know you mentioned being in Sweden right? What do you use as a decimal separator there? A comma perhaps? I think this may be the source of the error you’re getting and I’ll look into it for you. The number formatting I’m using may not work in your case so I’ll find an alternative, unless Bryan beats me to it.

For now, you can try running a version PRIOR to the last release (Rev 5). If the error doesn’t occur then that will confirm for me. thanks