Home / Forum / Builds and Things Built / MPCNC 2.8w $100 laser add-on complete / Reply To: MPCNC 2.8w $100 laser add-on complete

Profile photo of Maker BakerMaker Baker
Post count: 39
#7988 |

no this is my first attempt at flashing this. I have flashed my Prusa i3 with a RAMBO 1.3 mini from this tablet before with Arduino 1.0.6… I just installed Arduino 1.6.7 (IDE) and added the u8glib to my library and updated all libraries. I have com port 1 (only port on the tablet, used to flash Prusa before)… I have board: “Arduino/Genuino Mega or Mega 2560″…
I am getting a lot of red text when verifying. but it still compiles, so when I go to flash it, the load bar goes to the end and says processor time out and I get no response from the mpcnc no led flashing or anything