Home / Forum / Builds and Things Built / Dave's 24" x 24" Build / Reply To: Dave's 24" x 24" Build

Profile photo of Dave GunDave Gun
Post count: 92
#8335 |


Sure I will share my files. I don’t know what files would be best to use. Depending on the thinness of the acrylic your using, you may need to adjust the design files. I have them in 123D (free program). I converted each part to a 2D SVG file, but some parts required two SVG files that needed to be flip flopped and aligned in Estlcam.

The acrylic I bought was 1/4″ but it measured 5.08mm. The cuts that didn’t go all the way through are 2mm deep. The model is set up for these thicknesses.

I can’t attached it here, but you can download the D123 file here:

If you have any questions, let me know.