Home / Forum / Software / Laseretch Sizing Issue / Reply To: Laseretch Sizing Issue

Profile photo of karltinslykarltinsly
Post count: 279
#8871 |

Hi Ryan LB, I just created a drawing in paint and opened it at the correct size in LaserEtch. You’re probably doing all this, but just in case, here’s what I did.

1. Set the image size: go into properties, set units to inches, and enter 10 by 10.
2. Make your drawing as big as the canvas.
3. Save as BMP.
4. Open BMP in LaserEtch.

If you still have problems after verifying all that, can you zip and attach the picture you’re working with?