Home / Forum / Troubleshooting / 3D printer extruder issues / Reply To: 3D printer extruder issues

Profile photo of WalterWalter
Post count: 186
#9007 |

I’d guess that’s the issue then. get some jumpers and that should fix your issue.

I’m having what I assume is a firmware issue. in the photo you can see that I got my temp settings dialed in, but I’m having a problem with bulging corners. i imagine it’s a firmware setting. and I need to fix it because it causes the inside of holes to be smaller than the model because holes are technically just a bunch of corners. wondering where I should start tweaking. jerk, acceleration, etc.

  • This reply was modified 7 months, 2 weeks ago by Profile photo of Walter Walter.