Home / Forum / Troubleshooting / Shaking when above 200mm/m feedrate / Reply To: Shaking when above 200mm/m feedrate

Profile photo of RyanRyan
Post count: 125
#9082 |

doesnt really seem to matter if i run off of the SD card or not… same result… running GRBL instead of jtech in the software just doesnt work at all. im guessing the commands are different so id have to figure those out 🙂
it really sucks not being able to use a huge feature for why you bought your laser in the first place 🙂

EDIT : how would i go about disabling screen refreshes? i dont even want the LCD 🙂 but ill use it if i have to to make this work haha

  • This reply was modified 7 months, 1 week ago by Profile photo of Ryan Ryan.