Reply To: Shaking when above 200mm/m feedrate

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Shaking when above 200mm/m feedrate Reply To: Shaking when above 200mm/m feedrate

#9090
Profile photo of Leo69
Leo69
Participant

Probably a bit of both.As I understand it Laseretch only does black and white, not grayscale. That means there’s no need for constant laser power commands and it also means multiple “pixels” can be consolidated into one linear motion so I’m sure your right. If you want to do8bit grayscale then you have to accept that it’ll have to be done a bit slower. Your current 200mm ceiling should have lots of room for improvement though.