Reply To: Milled/printed Prusa Style Printer

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Milled/printed Prusa Style Printer Reply To: Milled/printed Prusa Style Printer

#9641
Profile photo of Ryan
Ryan
Keymaster

This is built for a snap on tool mount, kinda like my ramps case.

I am not a fan of auto bed leveling, but is in the firmware just add an endstop. Both my robos /hadit, I took it off one while I had to replace some bearings and will take it off the other. once the bed is level its good to go. I had to shim the robo bed with paper between the magnets but these prusa style 3 spring beds are simple to set. I guess I just have something against the z motors always working, add not perfect threaded rods in the mix and you get worse prints.