Home / Forum / Getting Started / First Crown – Z setting / Reply To: First Crown – Z setting

Profile photo of ManuCNCManuCNC
Post count: 44
#9944 |

You’re right, I can not use your firmware as the card I use it is a 32-bit … I use the firmware is still a derivative of Marlin ..
If you are not set are set in NORMALCLOSED NormalOpen?

Your project I will not use it for printing but only for milling and laser (which in the future would buy).

Yes! I printed the guide that you did for Estlcam … in fact I wanted to understand how to do before you try to take the crown

1) turn on the cnc and placed the pen on the paper
2) load the RH gcode
3) start
No G28