Reply To: Roller F conduit clamps are tight

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Roller F conduit clamps are tight Reply To: Roller F conduit clamps are tight

#9948
Profile photo of David
David
Participant

Yeah.. I’m pretty sure my printer’s extruder is fairly accurate. I haven’t done a calibration measurement in a while though… But all of the other parts have fit nicely and the rollers are very smooth. It’s just the Roller F clamp bulges out way too much. I’ve cracked a couple of the Roller F assemblies where the slot is by forcing it.. So I ended up using my dremel to shave out some plastic on the clamp so I don’t have to force the conduit in. Other then that everything has been going good! Once again.. Thanks for sharing this design with the world. Very impressive! Wish I had half of your design skills.. LOL