- JasonParticipantOctober 14, 2016 at 4:45 amPost count: 321
I bought a 2004 lcd so I could have an SD card slot for laser engraving since it is supposed to much smoother as apposed to send via USB.
I am using the B16_32-LCD-112515 firmware. Can I just plug in the LCD and I am good to go?vicious1KeymasterOctober 14, 2016 at 9:36 amPost count: 2627
That firmware is for the lcd in the shop. If you have the other lcd you will need to do a minor firmware edit.JasonParticipantOctober 14, 2016 at 9:38 amPost count: 321vicious1KeymasterOctober 14, 2016 at 9:40 amPost count: 2627
open the firmware it is all well commented, in config.h at the bottom of that tab
You must be logged in to reply to this topic.