Big problem about movement

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Big problem about movement

This topic contains 6 replies, has 4 voices, and was last updated by Profile photo of Ryan Ryan 1 year ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #14932
    Profile photo of TheAhmix
    TheAhmix
    Participant

    Image says more than thousand words…

    #14933
    Profile photo of Ryan
    Ryan
    Keymaster

    Do you have a bigger image? Is the issue where it is being cut? What software are you using to generate your gcode? Are you printing, milling, laser, drag knife, foam cutter, plasma cutting?

    #14990
    Profile photo of TheAhmix
    TheAhmix
    Participant

    Sorry for images my bad.There is a pictures of print preview and of movement. I dont know what do to.

    Attachments:
    #14994
    Profile photo of Barry
    Barry
    Participant

    What software did you use to make the g-code? Also, can you post the g-code?

    #14996
    Profile photo of Matt saeger
    Matt saeger
    Participant

    What exactly is the issue? Just that the cut is showing outside of the work area? If that’s the case that’s not a issue really.

    #15101
    Profile photo of TheAhmix
    TheAhmix
    Participant

    It cuts and in the middle of procces it loose movement and go wrong

    #15103
    Profile photo of Ryan
    Ryan
    Keymaster

    We are going to need a lot more information.

    A picture or video really helps.

    What hardware and electronics are you using? What software and settings?

    Lets see the g code.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.