CNC Automated Edge Finding/Zeroing touch plate

New Home Forum Hardware CNC Automated Edge Finding/Zeroing touch plate

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of PJM PJM 2 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #18311
    Profile photo of PJM
    PJM
    Participant

    Has anyone tried this with a RAMPS?
    If so, what do I need to do?
    Will it work with Repetier or do I have to use Estlcam?

    Like this:

    #18355
    Profile photo of PJM
    PJM
    Participant

    I’m guessing treating the plate like a mechanical end stop using “S” and “-” lines might work. Would you not have to use the plate to signal all three of X,Y, and Z though? Then you need to factor in the offset of the plate to set the machine to zero on the actual cutting stock correct?

    Anyone try this with RAMPS ?

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.