CoreXY 3d printer

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of Marco Marco 6 months, 4 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #13967
    Profile photo of Marco
    Marco
    Participant

    Hello! I’ve not gone. This is my new project, building a CoreXY 3d printer using MPCNC to make PLA parts. I was inspired by Thingiverse Fusebox printer but I had to redesign almost all printed parts to fit 23.5 x 23.5 profiles supplied by my local DIY shop.
    I’m waiting E3D V6 extruder from England ( 🙁 I would saved some euros if I’d wait Brexit … :-))) and then I’ll finished the assembly.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.