Corner_block2 slightly big… start again?

New Home Forum don’t use this one need to sort -Assembly – MPCNC Corner_block2 slightly big… start again?

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of enslaved_robot_boy enslaved_robot_boy 11 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #7561
    Profile photo of enslaved_robot_boy
    enslaved_robot_boy
    Participant

    First set of Imperial Corner_block2 parts measure 24 mm with calipers. Is 0.5mm too loose a fit?

    Don’t have any conduit yet but I want to keep printing if the dimensions are still ok.

    Any advice?

    Thanks!

    #7648
    Profile photo of vicious1
    vicious1
    Admin

    That is a bit large, positive you are printing the regular ones and not the IE version?

    How does your conduit fit?

    #7671
    Profile photo of enslaved_robot_boy
    enslaved_robot_boy
    Participant

    Thanks for the reply.

    The part slides easily on the rod. When use my hand to clamp it down there is more resistance, but it still slides.

    I think the problem is the diagonal arm length setting on my Rostock Max V2. Ahhh the pleasures of delta machines.

    Off to print calibration cubes.. sigh

    PS what do you think of the DC encoder version of the MPCNC in this video!? https://www.youtube.com/watch?v=uphXy3URQ6g

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.