Home / Forum / Getting Started / Cutting Carbon Fiber?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Profile photo of mattmatt
    Post count: 0
    #13354 |

    Hey all,

    I’m very interested in this project, specifically for cutting 3mm CF sheets into quadcopter frames. Will this rig be able to cut that?

    Profile photo of BarryBarry
    Post count: 334
    #13402 |

    Sure, as long as you use the right bit.

    Profile photo of EliBEliB
    Post count: 3
    #13646 |

    I only know this from the little research I’ve done into cutting CF for frames but be VERY careful about CF dust. Very bad stuff, like asbestos almost. You need a plan to contain the dust before you start cutting.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.