Don't try to use a 1.5" diameter bit in the 660!

New Home Forum Random or Off Topic Don't try to use a 1.5" diameter bit in the 660!

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Barry Barry 4 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #17437
    Profile photo of Barry
    Barry
    Participant

    It doesn’t like it. Also at 30mm/s it was still going to take days to plane off the top of my spoilboard even at 30% stepover.

    #17452
    Profile photo of vicious1
    vicious1
    Keymaster

    That’s a big bit! Was it a router bit or an endmill there is a difference. I use 45-50 step over for everything but finishing

    #17465
    Profile photo of Barry
    Barry
    Participant

    It’s a modified router bit. Started out life as a 1/2 inch rabbiting bit. I cut off the bearing post on the center. Was just an experiment, didn’t work! ?

    https://goo.gl/photos/BKJkiC3fZyK5RFjA7

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.