Extruder connection to arduino

New Home Forum don’t use this one need to sort -Assembly – MPCNC Extruder connection to arduino

Tagged: ,

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Eduardo Eduardo 11 months, 3 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #6818
    Profile photo of Eduardo
    Eduardo
    Participant

    Trying to connect extruder to arduino.

    Bought all from here.

    The Extruder has 2 white wires with a female plug and 2 red wires. The ramps wiring shows blue/white and orange/white. Can someone help with wiring.

    Thanks

    #6820
    Profile photo of JYount
    JYount
    Participant

    You are referring to the wiring diagram from this website, correct? http://www.vicious1.com/assembly/ramps-wiring/

    The blue/white wires are for the print fan. On your extruder, the two red wires are for the heater block. The two white wires on the extruder are for the thermistor for temperature control. On the vicious1.com diagram, the orange/white wires are for the extruder heater, which are your two red wires. The two white thermistor wires actually plug in towards the top of the ramps board, just next to the Z-axis stepper motor connection. This corresponds to the blue/black wires on the vicious1.com diagram.

    #6825
    Profile photo of Eduardo
    Eduardo
    Participant

    Thanks for the help

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.