Home / Forum / Assembly / Extruder mount hole..Screw Size Question

Viewing 2 posts - 1 through 2 (of 2 total)
  • Profile photo of Dwayne GonzalezDwayne Gonzalez
    Post count: 7
    #12157 |

    Was wondering what size bolt for the extruder mount. Everything bought from here.

    I figure it’s the .75″ bolt but the head is too big. I read he recent prints were a little tight. Should I drill it out or is it another screw?

    Profile photo of vicious1vicious1
    Post count: 2649
    #12178 |

    Picture didn’t show up, not sure which screw but they all should be the .75″

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.