extruder not heating

This topic contains 5 replies, has 2 voices, and was last updated by Profile photo of Matthew Matthew 10 months, 2 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #8779
    Profile photo of Matthew
    Matthew
    Participant

    my current setup is to have the extruder heater plugged in to d10, but according to my multimeter, no power being in received from d10 d9 d8 in 3d printer setup. any Ideas as to why this would happen.

    #8785
    Profile photo of nerdyrcdriver
    nerdyrcdriver
    Participant

    On the green connector going to the ramps board, did you connect + and – to the other two connectors?

    Should be like this
    http://www.vicious1.com/wp-content/uploads/2015/10/IMG_20151023_110317.jpg

    #8789
    Profile photo of Matthew
    Matthew
    Participant

    yep, I bought the kit from this web site so it came like that.

    #8790
    Profile photo of Matthew
    Matthew
    Participant

    buuuuuuut…
    I just checked the wire and it wasn’t properly attached. i just fixed it and we’re testing now.

    #8793
    Profile photo of Matthew
    Matthew
    Participant

    nope, didn’t work

    #8797
    Profile photo of Matthew
    Matthew
    Participant

    any other ideas?

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.