"F2" parts

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Jocke Vindgard Jocke Vindgard 4 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #17434
    Profile photo of Jocke Vindgard
    Jocke Vindgard
    Participant

    I started printing the International version a few weeks/months ago. And today when I was going to resume printing I found out that there are som “F2” versions available.

    I have already printed the “Bottom_Corner.STL” and “Lock_Corners.STL”. My question is if I can print the “Top_CornerF2.STL” without having any issues since the other parts are non “F2”. What do you recommend?

    Regards,
    Jocke

    #17451
    Profile photo of vicious1
    vicious1
    Keymaster

    The locks will be fine but you might as well reprint the bottoms. There was a spacing error, not much but best to print the right ones.

    #17468
    Profile photo of Jocke Vindgard
    Jocke Vindgard
    Participant

    Ok. Thanks for your quick answer!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.