Full graphic Controller resistor?

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 5 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #16301
    Profile photo of Bill K
    Bill K
    Participant

    Just purchased a full graphic 12864 controller board from AMazon. After ordering, I noticed the Vicious 1 version of this board (picture) has a resistor added to the back side of the board, which mine doesn’t have. Will I need to add this resistor to my board? Thanks for the advice!

    Attachments:
    #16303
    Profile photo of vicious1
    vicious1
    Keymaster

    Hopefully not, there are a bunch of bad ones out there with the wrong value resistor on them. That was needed to get the contrast right. Shouldn’t need it anymore, I need to get rid of that picture.

    #16304
    Profile photo of Bill K
    Bill K
    Participant

    Thanks for the reply and feedback. Love your website and admire the impact and your contributions have made with this technology. Thanks for that too!

    #16306
    Profile photo of vicious1
    vicious1
    Keymaster

    Thabks for that and your welcome!

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.