Gantry not square

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 10 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #9065
    Profile photo of Tad Ghostal
    Tad Ghostal
    Participant

    After finishing my assemble and ready to hook up the electronics I noticed that the gantry was not square. I am starting with the default machine dimensions and when the gantry is at one end of the frame the sides are off by at least a few 1/10″. Its not way, way off but its enough a quick glance suggest something isn’t quite right. The middle assemble printed great and everything fit together without really any extra effort (I did clean out the bolt holes with a 5/16″ drill). Is there a solution to get thing nice a square? I am really surpised how far off it is based on how well everything fit together.

    #9111
    Profile photo of vicious1
    vicious1
    Keymaster

    Triple check your frame. If that is nice and square and level my other suggestion is, I know it sucks, leave the center assembly on the rails, take out the 3″bolts, put it back together tightening all 4 a bit at a time. That will probably fix it.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.