Has anyone done their parts in PETG? If so, 70% infill still required?New Home › Forum › Mostly Printed CNC – MPCNC › Troubleshooting – MPCNC › Has anyone done their parts in PETG? If so, 70% infill still required?This topic contains 1 reply, has 2 voices, and was last updated by Jeffeb3 9 months, 1 week ago.Viewing 2 posts - 1 through 2 (of 2 total)Author PostsApril 8, 2016 at 3:42 am #10388 GannicusParticipantSeems to me that the recommendation of 70+% infill on these parts is extreme, even with PLA. But with ABS and now PETG, has anyone done their parts with these? If so, did you use less infill?Thanks!April 11, 2016 at 5:24 am #10518 Jeffeb3ParticipantI printed the XY motor mounts in PETG. I stayed with the 70% infill, and they seem to be pretty close to the same strength.Author PostsViewing 2 posts - 1 through 2 (of 2 total)You must be logged in to reply to this topic.