Help setting X Y and X axis

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Help setting X Y and X axis

This topic contains 4 replies, has 2 voices, and was last updated by Profile photo of Robert R Robert R 1 year, 3 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #10730
    Profile photo of Robert R
    Robert R
    Participant

    Hello…..

    I am new to this i have built my first MPCNC I have tried to cut several things with it my problem i am having is: when i cut something it stops towards the middle of the design and wont go any further, like it is out of room but there is at least 15″ of room to cut.

    Another problem, I click on the X and Y home buttons ( in the Repetier software) when my machine is at right most top corner it “Homes to the Center of the table. instead of the Lower Left corner.

    any help will be greatly appreciated.

    #10744
    Profile photo of Ryan
    Ryan
    Keymaster

    I think your problem is your table size settings in repetier. I think by default they are at 200mm x 200mm. You need to set them larger. As a safety if it goes further than the table size it will just stop.

    #10765
    Profile photo of Robert R
    Robert R
    Participant

    I have set my x and y to 900 same thing

    #10773
    Profile photo of Ryan
    Ryan
    Keymaster

    Are you using my firmware? If not there is a size setting in there as well. Mine is set to 1 or 2000 so you would be okay.

    #10957
    Profile photo of Robert R
    Robert R
    Participant

    The firmware was the problem thanks.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.