Here goes my build!

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of Teut Teut 1 year ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #14795
    Profile photo of Teut
    Teut
    Participant

    First, I have to say… Awesome design. I gave up looking for something like this 2 years ago… And stumbled across this accidently. Well 3 days, and 10 print hours later I have my first piece done… On my XYZ- da-chincy (misspelled on purpose) printer… In abs at a 90% fill… The only option available over 50% using their craptastic software/firmware. Wish me luck, I hope to finish printing in the next few months.. If I can stop the filament jams…

    #14965
    Profile photo of Teut
    Teut
    Participant

    5 days later 3 parts printed… 10 scrapped prints, 20 extruder jams… I had enough. 6 hours reseaching repetier firmware for my dachincy printer… 5 addition parts printed, the last 4 paused because of a filament tangle and finished sucessfully! Print detail… Much better… Jams.. Solved by being able to bump the extruder temp. Why didn’t I do this before now?!?!? Ugh.

    Attachments:
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.