Home / Endstop HELP

New Home Forum Software Development Home / Endstop HELP

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Nicolas d Nicolas d 1 year, 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #9311
    Profile photo of Nicolas d
    Nicolas d
    Participant

    Hello everyone! Here I’ll create a cnc me , but I have a question about Home, how does it operate since there have no endstop ? Im french thank you .

    #9315
    Profile photo of Drew Rogge
    Drew Rogge
    Participant

    If you don’t have end stops then you can’t use home. Without endstops the general consensus is that you position the machine to what you want to be 0, 0, 0 and then reset or power cycle the arduino. When it re-initializes it will set the current location to 0, 0, 0. If you have an LCD interface you can use “Prepare->Set home offsets” item to do the same thing.

    #9335
    Profile photo of Nicolas d
    Nicolas d
    Participant

    Ok, so I need 3 endstop ? But or place ?

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.