I could not get #6-32 X.75 (M3.5 X 20) bolt & nuts…

New Home Forum don’t use this one need to sort -Assembly – MPCNC I could not get #6-32 X.75 (M3.5 X 20) bolt & nuts…

This topic contains 5 replies, has 5 voices, and was last updated by Profile photo of ramajac ramajac 6 months, 2 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #14339
    Profile photo of Shin Sang Yeop
    Shin Sang Yeop
    Participant

    Here, I could not get [#6-32 X.75 (M3.5 X 20)] bolt & nuts…

    Can I use [M3 X 20] or [M4 X 20] bolts & nuts instead?

    #14349
    Profile photo of vicious1
    vicious1
    Keymaster

    Ebay or something similar? I am not sure how well the others will do. I would guess if you have to go with M3’s. M4 will need to get drilled out.

    #14361
    Profile photo of Jakob Andersen
    Jakob Andersen
    Participant

    I used M4, just drilled the holes a bit, works fine.

    M3.5 is not common, so would be cool to have the models with M4 instead 🙂

    #14362
    Profile photo of Shin Sang Yeop
    Shin Sang Yeop
    Participant

    Thank you! I will try M4.

    #14408
    Profile photo of Rui
    Rui
    Participant

    I used M3, so no problems for you 😉

    #14468
    Profile photo of ramajac
    ramajac
    Participant

    Had the same problem here, and as someone said drilling worked fine, cause you only enlarge the holes like 0,35mm. Isn´t a big issue for the holes on the edge of some parts.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.