Intermediate walk through

New Home Forum Getting Started Intermediate walk through

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 1 month, 4 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #19154
    Profile photo of Pinhas Gold
    Pinhas Gold
    Participant

    I’m using the mpcnc with marlin and tried out to mill both Left and Right parts for LCD controller enclosure. Attached is the Left side picture I have milled today, made out of Teak wood and the process and the results are wonderful. however, have some difficulies to modify the Left part using Estlcam in order to mill the right side. This is probably due to my lack of knowledge and experience.
    Could you please share a working gcode for the Right side as well?

    Thanks a lot

    Attachments:
    #19193
    Profile photo of vicious1
    vicious1
    Keymaster

    I don’t think I saved it, If I can find it I will post it but follow the walkthrough, the right side is the same just less steps than the left.

    #19211
    Profile photo of Pinhas Gold
    Pinhas Gold
    Participant

    Thanks, I’ll try to use Cambam instead of Estlcam as it looks more stable and at least has the UNDO function.

    #19220
    Profile photo of vicious1
    vicious1
    Keymaster

    You can “undo” in estlcam. Use the select tool to select the path, from there you can either edit or delete it.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.