Marlin, Estlcam & Circles

New Home Forum Software Development Marlin, Estlcam & Circles

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of Franz Maier Franz Maier 1 year, 2 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #13049
    Profile photo of Franz Maier
    Franz Maier
    Participant

    I have the following problem:

    using the G02 Command in ESTLCAM for circles, they dont get circular, if they have a small diameter (~<3mm) Using multiple points the circles look ok. See image. I think, the GCODE looks ok, so I assume the Problem in Marlin transfering G02 to toolpath. Does anyone know this behaviour?

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.