Milled part is mirrored and turned clockwise 90 degree

New Home Forum Troubleshooting Milled part is mirrored and turned clockwise 90 degree

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Joakim Joakim 2 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #18371
    Profile photo of Joakim
    Joakim
    Participant

    I have had my mpcnc working but when I cleaned up the cables the result is so strange… The milled part is mirrored and turned clockwise 90 degree.
    When I manually drive the cnc with Repetier it behaves correctly. X+ is up, X – is down, Y + is right and Y – is left. But when I send a gcode for milling I get this strange result.

    Any idea whats wrong?

    #18389
    Profile photo of vicious1
    vicious1
    Keymaster

    Y+ is up/away from you
    x+ is to the right

    #18393
    Profile photo of Joakim
    Joakim
    Participant

    Ahh… Emerassing – Thanks! Time to reboot my brain 🙂

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.