mp3dp steppers getting hot

Tagged: 

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of John John 11 months, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #16170
    Profile photo of John
    John
    Participant

    so the X and Y steppers on my MP3dp were getting really warm to the touch when printing anything of length.
    Z felt fine.

    I measured the voltage on the 8825 drivers and they were at .7 volts as expected.
    I adjusted the X and Y drivers down to .630 (see the video under assembly if you don’t know how) and it seems to be printing very solid and the steppers run cool.

    just in case someone else runs into a similar issue.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.