Home / Forum / Getting Started / MPCNC Bootstrapping

Viewing 2 posts - 1 through 2 (of 2 total)
  • Profile photo of fougerefougere
    Post count: 0
    #10590 |

    A big thank you to Ryan for the hard work he put into this project !
    The design is simple and elegant 🙂

    I’d like to build a MPCNC, but I don’t have access to a 3d printer, and I’m on a tight budget.
    I was thinking I could bootstrap one : use the spindle to manually carve rough approximations of the printed parts in wood or plastic. Then print/mill better ones after I get something that works.

    I’m pretty sure that would work for the corners pieces, but not so much for the rollers/Z-axis.
    Anyone got some experience with that ?

    Or are there alternative non-printed designs for the complex parts?

    Profile photo of vicious1vicious1
    Post count: 2649
    #10599 |

    No alternatives yet (I really want to make some millable parts for V2). You can mill the parts but most would take a minimum of 4 turns.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.