MPCNC in Davao Philippines

New Home Forum Builds and Things Built MPCNC in Davao Philippines

This topic contains 5 replies, has 4 voices, and was last updated by Profile photo of autox3d autox3d 2 months, 2 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #17797
    Profile photo of autox3d
    autox3d
    Participant

    One inch size, with 400 watt router spindle, 4×4 foot work area.

    Using ABS coated steel pipe racking table and 1.5 inch plywood top.

    One mod for the machine was using stainless one inch pipe flanges that cost $2 each instead of the printed ones.

    MPCNC

    #17798
    Profile photo of autox3d
    autox3d
    Participant

    finished out, I used Belden 22ga shielded wire and GRBL controller.

    #17801
    Profile photo of vicious1
    vicious1
    Keymaster

    Looks good. Lets see some videos of that giant thing in action when you start using it!

    #17808
    Profile photo of James Donnelly
    James Donnelly
    Participant

    Do those flanges give good a rigid upright? Normally they have a set screw/grub screw don’t they? Wouldn’t that allow the upright to move more than if it’s clamped (like the printed part)? Perhaps it doesn’t matter.

    #17837
    Profile photo of Alvin
    Alvin
    Participant

    looks great! where do you get your stuff from Davao? online or Manila?

    #17848
    Profile photo of autox3d
    autox3d
    Participant

    I hand carried it all from Manila on a boat to CDO then a harrowing van ride across Mindanao where we had several near death experiences due to the van drivers idiocy.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.