Need help guys

New Home Forum Getting Started Need help guys

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 1 month, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #20349
    Profile photo of Karl Hutson
    Karl Hutson
    Participant

    Having put my mpcnc altogether, I load all arguing software and repeiter-host software. I was able to move everything fine with the manual controls. The next day powered it all back up again but now the steppers are wining a high pitched noise, won’t move and repeiter-host says no start signal – forcing start. What’s gone wrong please help!!!!!!

    #20354
    Profile photo of vicious1
    vicious1
    Keymaster

    Screen shot of the errors please. Make sure no wires come loose.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.