New Corner Block Leg issue

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC New Corner Block Leg issue

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of RAGII RAGII 1 year, 2 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #12070
    Profile photo of RAGII
    RAGII
    Participant

    So I realized that I never put the upper leg pieces on my corner blocks before I squared it all up. I went back to do 1 corner at a time and discovered that the nut is protruding past the bottom of the corner piece so the conduit will not sit in there flush. Am I doing something wrong?

    EDIT:

    DUH!!! I am doing something wrong. If you simply put the screw head on top and the nut underneath everything works fine. It has obviously been a long day for me so I think I should quit while I am ahead (a little behind?). I feel like an idiot for not realizing this issue sooner.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.