Home / Forum / Assembly / New tool mount

Viewing 2 posts - 1 through 2 (of 2 total)
  • Profile photo of RickTRickT
    Post count: 1
    #13300 |

    It’s not mentioned in the assembly instructions, but is it intended for nuts to be glued into the back of the tool mount during assembly of the z axis?

    Profile photo of vicious1vicious1
    Post count: 2649
    #13305 |

    Either way. I glued in the 2 lowest ones because all my mounts use those but I am able to get in there pretty easily to change the others. I don’t switch tools too often though since I run multiple machines.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.