New Tool Mounts?

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 7 months, 4 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #13066
    Profile photo of Dave Yurko
    Dave Yurko
    Participant

    So in the new May 2016 section where the new parts have been updated it states:
    Cons:
    All new tool mounts will be needed, I have posted a blank to make that as easy as possible, http://www.thingiverse.com/thing:805803
    Does this mean all of the mounts in Thingiverse wont fit the new Z? I ask because I am ready to have parts printed and dont want to waste time and rescources. Thanks in advance for your time…

    #13068
    Profile photo of vicious1
    vicious1
    Keymaster

    Correct, as far as I know the only tool mounts are the 2 I posted for the dewalt and the extruder.

    #13077
    Profile photo of Dave Yurko
    Dave Yurko
    Participant

    Thanks for the reply. The next question would be, jump right in, or do I wait for the new 25.4mm machine update? Not asking for an eta, just your opinion 😉
    I am planning a 24″x36″ work area for my build. Thanks!

    #13078
    Profile photo of vicious1
    vicious1
    Keymaster

    If you can get conduit that fits either of the current 2 machines there is no reason to wait, it is not any different, just .4mm more room.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.