Nut Traps got bumped – still usable?

New Home Forum Troubleshooting Nut Traps got bumped – still usable?

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 2 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #18735
    Profile photo of Geoff Brown
    Geoff Brown
    Participant

    The spool got pulled off the ledge and bumped my printer while it was making the nut traps. They were almost done; can I just give them a little sanding and maybe drill the hole out a little? Or, am I better off printing new ones?

    Attachments:
    #18738
    Profile photo of vicious1
    vicious1
    Keymaster

    As long as you can get the screw through that it’s fine. It’s just there to keep the nuts from spinning.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.