Home / Forum / Troubleshooting / Pen test with Vicious logo issue

Viewing 3 posts - 1 through 3 (of 3 total)
  • Profile photo of AlvinAlvin
    Post count: 31
    #16287 |

    So I tried a pen test using the Vicious logo but stopped it when I checked and it’s in reversed 🙂 Not sure if I just need to reverse the x & y plugs to correct this

    EDIT : 🙂 reversed the x and y pins and now it’s fixed

    • This topic was modified 2 months, 1 week ago by Profile photo of Alvin Alvin.
    Profile photo of BarryBarry
    Post count: 334
    #16293 |

    It’s real fun when your 3d printer prints reversed and you can’t quite figure out why parts don’t work quite right!

    Profile photo of vicious1vicious1
    Post count: 2677
    #16295 |

    Flip the x axis, y would make it upside down.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.