Printer mods?

New Home Forum Hardware Printer mods?

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of autox3d autox3d 1 month, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #19458
    Profile photo of autox3d
    autox3d
    Participant

    Is there a set of files to be able to mod the new printer design?

    Specifically I am looking to be able to use half inch rod and bushings. I have a good amount of straight half inch stainless rod in stock here and several hundred self lubricated bushings for it.

    Since the bushings are smaller OD than the bearings, it seems that there would not be much to mod aside from the rod holders and bearing holders?

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.