Problem about movement in process

New Home Forum Troubleshooting Problem about movement in process

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 2 months, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #18033
    Profile photo of TheAhmix
    TheAhmix
    Participant

    Hello everybody,
    I have a problem with my mpcnc and when it is in process it go wrong and everything is at final only a crap.

    Images:
    http://postimg.org/gallery/ykryyawg/

    #18035
    Profile photo of vicious1
    vicious1
    Keymaster

    Sorry you didn’t really give any info to go off of.

    These things should all be included in your post. It makes it much faster to diagnose problems.

    1) Did you buy everything from here?
    a)If you didn’t or changed some things please don’t leave out any details.
    b)What firmware?

    2) Are you using end stops?
    a)If so please disconnect them.

    3) Are you using all my recommended parts?
    a) If not please list what parts you used.

    4) Include a picture so obvious errors might be spotted.

    #18036
    Profile photo of TheAhmix
    TheAhmix
    Participant

    Sorry my bad…
    I buy everything on ebay but all of parts are from list, firmware is yours with fg display, I dont use end stops and when I use laser and different software it works great. Is it a problem with estlcam? Maybe you can send me a good gcode to try it :/

    #18038
    Profile photo of vicious1
    vicious1
    Keymaster

    There is test code in the estlcam basics page. It is probably your speed settings, start with x and y movements at 10mm/s and Z at 3mm/s see if that helps. If it does work your way back up.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.