- CesarParticipantMay 13, 2016 at 10:59 amPost count: 14
Hi every one as you will see from my question I am a newbie. I am at a loss as to why after installing arduino software 1.6.9 my laptop is able to recognize an arduino uno R3 original not a clone and it assign a port with no issues. When I try to do the same with my Arduinomega which has the ramps1.4 shield as installed by vicious1 it does not assign a port but it continues to ask for a serial driver? The ramps board is working perfectly with the full graphic control screen (only the screen is unable to be contrast adjusted) “side issue” I am able to move the motors with no problem using the Marling contols via the screen inter phase with no issues.?? any help Please!vicious1KeymasterMay 13, 2016 at 1:05 pmPost count: 2657
Mac or PC? Mac need different settings, found on the ramps assembly page.vicious1KeymasterMay 13, 2016 at 1:37 pmPost count: 2657
It is a driver issue with XP. There is a driver that works but I don’t have experience with it. XP is pretty old now.CesarParticipantMay 13, 2016 at 3:35 pmPost count: 14
HI I have found several ways of solving this issue of the missing XP driver for arduino mega 2560 r3
1)How to install Chinese Arduino Mega 2560 Drivers.
http://wch.cn/download/CH341SER_ZIP.html quick downloan then lauch set up
2)Arduino Forum Using arduino=>Installation & Troubleshooting=>Topic started by:d0m3on jan 10 2012 posted jan 10 2012 9:38 pm
3) http://arduino.cc/en/Guide/Windows#toc4 I chose the firt
I discovered a you tube video explaining the same it is in Spanish wich i am fluent on this is the link https://www.youtube.com/watch?v=FhmG5J-AHrg
Thanks for the help vicious1
You must be logged in to reply to this topic.