Questions for the intermediate walk through

New Home Forum Updates Questions for the intermediate walk through

Tagged: 

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of Ryan Ryan 1 month, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #14905
    Profile photo of Ryan
    Ryan
    Keymaster

    ESTLCAM – 2.5D Routing- Intermediate

    Ask your questions here and I will try and answer you and clarify the walkthrough.

    #27589
    Profile photo of smit
    smit
    Participant

    hey can your share your estlcam setup with me, because i tried using nema 23 and 17 motor on 20v when i program the ramps 1.4 board on A4988 motor drivers the motors does not move.

    #35134
    Profile photo of Alex Hodge
    Alex Hodge
    Participant

    Hey Ryan,
    Looks like the ESTLCAM file in your intermediate walkthrough is an old version and cannot be used by the current version of ESTLCAM. Not sure what you can do about it. There doesn’t seem to be any way to update an e8 file to an e10 file and if you try renaming the extension, it just tells you “this file was created by an older version and it isn’t possible to open it”…or something along those lines.
    Just a heads up.

    #35136
    Profile photo of Ryan
    Ryan
    Keymaster

    Aww Man, I will have to redo it. The walkthrough should still be relevant though. Thanks for the heads up.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.