Recommended router bits

New Home Forum Getting Started Recommended router bits

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Matt saeger Matt saeger 1 month, 2 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #19892
    Profile photo of andy1989
    andy1989
    Participant

    Can anyone recommend a good source of router bits in the UK?

    Also what router bits would you recommend? Iv never done any milling before so i have no idea where to start.

    one, two, three or four flutes. 1/4 inch or 1/8 inch. endmill or slot drill?
    Will one cutting bit be suitable for aluminum, plastic and MDF, or do i need to use different bits for each material?

    I also still need to purchase a router, i assume the dremmel i have sitting the draw wont be anywhere near powerfull enough.

    Has anyone used one of these makita copies from ebay?
    http://www.ebay.co.uk/itm/281944547910?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

    #19897
    Profile photo of Matt saeger
    Matt saeger
    Participant

    I used my dremel for a while and it worked fine. Use what you have and upgrade later. All you need to do is print another mount.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.