Rotosaw+ by RotoZip

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Rotosaw+ by RotoZip

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of P3DCNC P3DCNC 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #24709
    Profile photo of P3DCNC
    P3DCNC
    Participant

    So I was going to use my Rotozip saw that I had but it needed a new bearing. $30. Finally got the old one off, new one on, then lost a rubber piece that holds the small bearing at the other end. So long story short, new rotary saw time.

    Opted for the Rotosaw+ instead of the DM660. 6.0A 15-30K rpm for $139 CDN.

    Anyone use this one ? Off to look for mounts or make em.

    https://www.homedepot.ca/en/home/p.120-v-spiral-sawsupsup-kit.1000663837.html

    #24796
    Profile photo of P3DCNC
    P3DCNC
    Participant

    Got to try out the Rotosaw+ last night. Nice. The speed stays pretty solid during cuts which is nice. It does come with a 5/32 collet which I will buy some bits for since I figure that’ll clean the cuts up with a stiffer bit (I could be wrong). But I borrowed the 1/8 collet from my older now parts Rotozip.

    Made a mount and dust collector, will share once I’ve made a few adjustments.

    Anyway, next time I’ll try to dial in the feeds and speeds…

    • This reply was modified 1 week ago by Profile photo of P3DCNC P3DCNC.
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.