Scale problem in Repetier-Host

New Home Forum Getting Started Scale problem in Repetier-Host

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 2 weeks, 2 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #21371
    Profile photo of mogey336
    mogey336
    Participant

    I have a scale problem when i use the demo crown in Eslcam and then load the gcode in Repetier-Host the crown is soo small
    What is the problem after scaling it in Eslcam

    #21373
    Profile photo of vicious1
    vicious1
    Keymaster

    These things should all be included in your post. It makes it much faster to diagnose problems.

    1) Did you buy everything from here?
    a)If you didn’t or changed some things please don’t leave out any details.
    b)What firmware?

    2) Are you using end stops?
    a)If so please disconnect them.

    3) Are you using all my recommended parts?
    a) If not please list what parts you used.

    4) Include a picture so obvious errors might be spotted.

    What is really small in actual measurements? What size should it be?

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.