Small parts holders.

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Barry Barry 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #13801
    Profile photo of Barry
    Barry
    Participant

    This started out as a test of an Aztec/Mayan glyph. It turned out okayish, but not that great, mostly because I’m just using scrap plywood I had laying around. I made the test tube holder today, and needed to put a back plate on so I could screw it to the wall, and though what the hell, it doesn’t look that bad!

    The tubes are 50ml centrifuge tubes that I get coffee in, I have a couple dozen sitting here collecting dust and thought, I know what to do with these!

    #13820
    Profile photo of vicious1
    vicious1
    Admin

    Slick, I like it. And that coffee site…pretty cool.

    #13824
    Profile photo of Barry
    Barry
    Participant

    The coffee is addictive, luckily it’s expensive, so I don’t get it that often.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.