Squaring the XY, something different

New Home Forum Troubleshooting Squaring the XY, something different

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of vicious1 vicious1 3 weeks, 4 days ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #21007
    Profile photo of vicious1
    vicious1
    Keymaster

    So this evening I took out the OG cnc from mothballs. It has been sitting collecting dust since the move. Gave it a once over and of course the gantry was not square anymore…Thought I could fix it in a few minutes. Ended up taking the whole gantry off (glad I have a wiring harness on that one). Spent some time and just could not get it square. I kept thinking “if I can’t do this…I’m in trouble”. Well I spent at least 30 minutes on it and had all the tension pretty equal on all bearing groups and it was still off. Each time I checked it if was off by a different amount wide and narrow.

    Turns out one of the conduit is an oval I guess, all I had to do was rotate/twist it and dead nuts…

    When I was giving it the once over I rotated the tubes so they would be on fresh zinc, well that threw it all out of whack. New one for me. Hope it helps someone.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.